Help – Kenwood DNX9240BT User Manual
Page 90

90
DNX9240BT/DDX8024BT/DDX8054BT
Help?
Troubleshooting
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
▲
Subwoofer is not set to On.
☞
(page 73)
▲
The DSP Select is Bypass.
☞
Control> (page 72) ▲ The Dual zone function is enabled. ☞ Control> (page 56) ▲ The unit is set to STANDBY source. ! • Cannot select the output destination of the subsource in the Dual zone. • Cannot adjust the volume of the rear speakers. ▲ The Dual zone function is disabled. ☞ Control> (page 56) ! Cannot play audio files. ▲ "CD Read" of "2". ! Cannot Folder select. ▲ The Random play function is enabled. ! Cannot perform Repeat play. ▲ The PBC function is enabled. ! • Cannot set up the equalizer. • Cannot set up the crossover network. ▲ The Dual zone function is enabled. ☞ Control> (page 56) ▲ The DSP Select is Bypass. ☞ Control> (page 72) ▲ The equalizer is set to "iPod". ☞ Control> (page 55) ▲ The unit is set to STANDBY source. What might seem to be a malfunction in your unit General ? The Touch Sensor Tone doesn’t sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can’t be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on Disc source ? The specified disc does not play, but another one plays instead. ✔ The specified CD is quite dirty. ☞ Clean the CD. ✔ The disc is severely scratched. ☞ Try another disc instead. Audio file source ? The sound skips when an Audio file is being played. ✔ The media is scratched or dirty. ☞ Clean the media, referring to the CD ✔ The recording condition is bad. ☞ Record the media again or use another media. B64-4382-00_00_E_En.indd 90 B64-4382-00_00_E_En.indd 90 09.2.19 1:04:09 PM 09.2.19 1:04:09 PM
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
cleaning of the section on
(page 6).