Kenwood TK-2260EX - Manual (Page 11)

3
INSTALLING THE BELT CLIP
Note: When first installing the belt clip, you must remove the
battery pack from the rear of the transceiver.
Plastic
covering
1 Remove the 2 screws from the
rear of the transceiver, then
remove the plastic covering that
was held in place.
Belt clip
2 Insert the belt clip mount into
the space on the rear of the
transceiver.
3 Using the 2 screws, affix the belt
clip in place.
◆
When the belt clip is not installed, leave the plastic covering in
place.
◆ Do not use glue which is designed to prevent screw loosening
when installing the belt clip, as it may cause damage to the
transceiver. Acrylic ester, which is contained in these glues,
may crack the transceiver’s back panel.