Kenwood DDX5026 - Manual (Page 5)

English | 5
ANT. CONT P.CONT
MUTE
REVERSE
REMOTE CONT STEERING WHEEL REMOTE INPUT
2WARNING
Connecting the ISO Connector
The pin arrangement for the ISO connectors depends on
the type of vehicle you drive. Make sure to make the proper
connections to prevent damage to the unit.
The default connection for the wiring harness is described
in 1 below. If the ISO connector pins are set as described
in 2, make the connection as illustrated.
Please be sure to reconnect the cable as shown 2 below
to install this unit to the Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the vehicle’s
ISO connector is linked with the ignition, and
the A-4 pin (yellow) is connected to the constant
power supply.
Unit Vehicle
A-7 Pin (Red)
A-4 Pin (Yellow)
Ignition cable (Red)
Battery cable (Yellow)
2 The A-7 pin (red) of the vehicle’s ISO connector
is connected to the constant power supply, and
the A-4 pin (yellow) is linked to the ignition.
Unit Vehicle
A-7 Pin (Red)
A-4 Pin (Yellow)
Ignition cable
(Red)
Battery cable
(Yellow)
Accessory 1
FUSE ( 15A )
GPS Antenna (Accessory 3)
(see page 8)
Bluetooth Microphone
(Accessory 2) (see page 8)
B54-4763-00_00_DNX5_E_En_r1.indd 5 B54-4763-00_00_DNX5_E_En_r1.indd 5 09.11.11 5:36:33 PM 09.11.11 5:36:33 PM