Kenwood NX-720GE - Manual (Page 15)

11
5 Press the / key to select the status you want to transmit.
• If Manual Dialing is enabled, you can enter a station ID by using the microphone
DTMF keypad (refer to step 3, above).
6 Press the PTT switch to initiate the call.
• “COMPLETE” appears on the display when the status has been successfully
transmitted.
■ Receiving
A calling ID or text message will appear when a Status call is received. Press any key
to return to normal operation.
■ Reviewing Messages in the Stack Memory
1 Press the key programmed as [Stack], or press and hold the key programmed as
[Selcall], [Status], or [Selcall + Status] to enter Stack mode.
• The last received message is displayed.
2 Press the / key to select the desired message.
• Message types are identified as follows:
ID: Caller ID, ST: Status Message, ME: Short Message
• Press and hold the S or key for 1 second to cycle the display information as
follows:
ID Name > Status/Short Message > CH/GID
3 Press the key to return to normal operation.
• To delete the selected message, press the A or # key. To confirm the deletion,
Press the S or key.
• To delete all messages, press and hold the A or # key for 1 second. To confirm
the deletion, Press the S or key.
SHORT MESSAGES
This transceiver can receive short data messages which contain a maximum of 48
characters.
• Received short messages are displayed the same as Status messages. A maximum of
15 received messages (combined status messages and short messages) can be stored
in the stack memory of your transceiver.
GPS REPORT
GPS data can be manually transmitted by pressing the key programmed as [Send the
GPS data]. If set up by your dealer, GPS data may be automatically transmitted at a
preset time interval.
• When using the NX-720G/ NX-820G, you must connect a KRA-40 GPS antenna.
• When using the NX-720/ NX-820, you must connect an external GPS unit.
• When the power is turned ON and/or the reception condition of the GPS satellite is
poor, positioning completion time may take longer.