Kenwood DNX5240BT - Manual (Page 80)

80 DNX5240BT/DNX5240/DDX5024/DDX5054/DDX54R
Tone Setup
You can set a Tone curve.
1 Display the Tone screen
See (page 79).
2 Set the Tone
1
2
3
4
5
6
7
8
9
1 Tone curve becomes flat.
2 Bass adjustment items are displayed.
3 Middle adjustment items are displayed.
4 Treble adjustment items are displayed.
5 Sets the Center frequency.
6 Sets the level.
7 Sets the Q factor. (Only Bass and Middle can
be set)
8 Bass DC Extend settings (Only when Bass is
selected)
If turned "ON", it extends the bass
center frequency to the low register by
approximately 20%.
9 Returns to the "Equalizer" screen.
Audio Control
Zone Control
You can set the front and rear audio source.
1 Display Zone Control
Touch in the "Audio
Control Menu" screen (page 78).
1
1 Displays the current source.
2 Set the Zone Control
2
3
3
4
2 Turns the Zone Function (that sets different
source sounds for front and rear speakers)
On or Off.
3 Sets the front and rear audio source
separately.
(This button appears when the Zone
function is On.)
⁄
• When the rear speaker sound is switched, the audio
source that is output at the AV OUTPUT terminal is also
switched to the same source.
4 Adjusts the volume of the rear channel.
(This button appears when the Zone
function is On.)
⁄
• There are following limitations when zone function is set
to "On".
- There is no output from the subwoofer.
- (page 56) and
(page 79) are not available.
- When "DVD" or "USB" is selected as the front source, the
rear source can be selected from "Front" (same source
as front), "iPod" or "VIDEO", etc. When the rear source is
B64-4258-00_00.indb 80 B64-4258-00_00.indb 80 08.10.30 7:28:34 PM 08.10.30 7:28:34 PM