Kenwood C-BX3 - Manual (Page 11)

11
English
Troubleshooting
If you have a problem with this System, check this list for a possible
solution before calling for service.
Power
Power does not come on.
The power cord is not inserted securely. Plug it in securely.
=
The unit suddenly turns off.
Auto power save function is on. Refer to “Activating/deactivating =
APS (Auto Power Save)” in “Basic operation.”
Remote control
The remote control does not work.
Pull out the insulation sheet.
=
Sunlight is shining directly on the remote sensor. Hide the remote
=
sensor from direct sunlight.
The path between the remote control and the remote sensor on
=
the front panel is blocked.
Point the remote control at the remote sensor on the front panel.
=
Signals cannot reach the remote sensor. Move closer to the unit.
=
The battery is exhausted. Replace the battery. =
External components
No sound can be heard when DIGITAL 1 or DIGITAL 2 is
selected as a source.
Check the output setting of the connected digital components. =
Set the output setting to PCM signal. (Refer to “Specifications” for
more information.)
iPod
iPod cannot be connected firmly.
Check to see whether the connector between iPod and the unit is =
not damaged, and connect it.
iPod does not provide sound.
iPod is not properly connected. Remove iPod from the unit, and =
then connect it again.
iPod cannot be charged.
iPod is not properly connected. Remove iPod from the unit, and
=
then connect it again. After connecting iPod, turn on the power
again.
Specifications
Output Power : 30 W + 30 W RMS (1 kHz, 10% T.H.D., 4 Ω)
Audio section
Input Terminals : ANALOG IN : 1 V/50 k Ω
Digital Input Terminals* :
DIGITAL IN 1 (OPTICAL) : –21 dBm to –15 dBm (660 nm ±30 nm)
DIGITAL IN 2 (COAXIAL) : 0.5 Vp-p/75
Ω
Output Terminals : SUBWOOFER PRE-OUT : 400 mV/10 k Ω
Speaker section
Type : Bass-Reflex Type
Speaker : 80 mm cone × 2
Impedance : 4 Ω
Frequency Range : 50 Hz to 25 kHz
Sound Pressure Level : 84 dB/W•m
General
Power Source (DC IN) : DC 19 V 3.37 A
AC Adaptor (AC-190337A) :
Input : AC 110 – 240 V
, 50 Hz/60 Hz, 1.5 A – 0.9 A
Output : DC 19 V 3.37 A
Power Consumption : 0.5 W or less (in Standby mode)
Dimensions (W × H × D) :
Whole system (assembled) : 500 mm × 550 mm × 400 mm
Main unit (with top glass) : 500 mm × 110 mm × 300 mm
Weight (nett) :
Whole system (assembled) : 13.2 k
g
Main unit (with top glass) : 8.0 k g
Maximum loadable weight : 20.0 k g
iPod
Output Power : DC 5 V 1 A
Video Out (VIDEO OUT) : Composite
* Corresponding to Linear PCM only (with sampling frequency — 32 kHz,
44.1 kHz, 48 kHz)
When an audio signal other than Linear PCM comes in, NONPCM –
appears on the display.
Design and specifications are subject to change without notice.
EN_C-BX3[E]f.indd 11 EN_C-BX3[E]f.indd 11 7/4/12 9:44:42 AM 7/4/12 9:44:42 AM