Siemens LF259RB50 - Manual (Page 19)

Interval Function:
A specific function of this appliance is the
Interval Function which consists in
activating the motor in automatic way 10
minutes each hour at the speed flashing in
the display.
This function can be activated on the
control of the hood or by remote control.
Interval Function by controls:
‰
Keep pressing at the same time the O
and + push buttons, then release
them: the display will show the 1;
19
‰ Keep pressing at the same time the +
push button, the display will show
the following for the speeds of the
motor 2→3→1→2 …;
‰ Keep pressing at the same time the O
and + push buttons to confirm the
speed for the motor you wish for the
interval function.
Interval Function by remote control:
‰ Keep pressing the : push button.
The display will show 1;
‰ Keep pressing the + push button, the
display will show the following for the
speeds of the motor 2→3→1→2 …;
‰ Press the push button to confirm
the speed of the motor for the interval
function.
When you are in the setting phase, if the
interval function shown is not confirmed
within some seconds, then you get out of
the setting mode for the interval function.
By pressing any push button, light
excluded, the interval function is excluded.
The remote control has a battery – When
the battery is exhausted you need to:
1. loosen the 2 screws on the rear part
and remove the cover.
2. take the battery out and replace it with
one with the same characteristics.
3. Close the cover again and tighten the
screws.
Follow National norms for waste disposal
of exhausted batteries.