Code, Gas burners, Switching on manually – Siemens EC675PB21E User Manual
Page 11: Switching on automatically, Release the control knob, Turn the control knob to the required setting, Risk of deflagration, Safety system, Switch on the burner as usual
11
--------
Code
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.
Gas burners
There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.
Switching on manually
1.
Press the chosen burner control knob and turn it
anticlockwise to the required setting.
2.
Use any type of lighter or flame (cigarette lighter, matches,
etc.) and bring it close to the burner.
Switching on automatically
If your hob can be switched on automatically (ignition
sparkers):
1.
Press the chosen burner control knob and turn it
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks are
produced on all burners. The flame ignites.
2.
Release the control knob.
3.
Turn the control knob to the required setting.
If it does not come on, turn the control knob to the off setting
and repeat the steps above. This time, press and hold the
control knob for longer (up to 10 seconds).
:
Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off the
burner and open a nearby window or door. Wait at least one
minute before trying to switch the burner back on.
Safety system
Depending on the model, your hob may have a safety system
(thermocouple) that prevents the flow of gas if the burners
accidentally switch off.
To ensure that this device is active:
1.
Switch on the burner as usual.
2.
Without releasing the control knob, press and hold it down
firmly for 4 seconds after lighting the flame.
Simmer Plate
This accessory has been
designed to reduce the level
of heat at the lowest power
setting.
Place the accessory directly
on the pan support with the
cones facing upwards, never
directly over the burner. Cen-
tre the pan over the acces-
sory.
Simmer Cap
Lid specially designed to
cook at minimum power. For
its use, the Simmer Cap
needs to be placed on the
auxiliary burner cap.
HZ298107
Additional wok pan support: cast iron
HZ298110
Additional wok pan support: steel enamel
HZ298114
Additional coffee maker support
HZ298105
Simmer Plate
HZ298128
Simmer Cap
LJQLWLRQVSDUNHU
WKHUPRFRXSOH