Electrix Tweaker Editor Reference - Manual (Page 17)

5. Tools
17
message this sends. Just type in a note number into the box and the note will be sent, or type in a
velocity value and the note will be sent. You can alter the properties of the note with the velocity
and duration field.
This is useful for testing LED’s on a one-by-one basis, and observing how different velocities affect
the illumination. If you want to keep an LED illuminated, turn on the no note off button so a note off
is never sent and the LED will stay on. It is also useful for testing LED rings and their different modes.
Just type in a CC number, then scroll through values in the value number box to send a stream of
CC values to an LED ring.
Send Many Notes
If you want to see all the button LED’s illuminate in succession, use the send many notes tool. You
can set a range of notes with the min and max settings. Change the timing with the interval number
box. You can set the duration of the notes using the duration field in Send Single Note. Press Go to
start the cycle and Stop to cancel it. If you want the cycle to keep running, turn on Loop.
Send CC Ramps
Similar to the Send Many Notes tool, but sends ramps of data on successive continuous controller
numbers. Use the min and max values to set the range of CC numbers you want to send, and use the
interval setting to determine how fast the ramp is. For example, if you set the range to CC numbers
0-4 and an interval of 10, the program will send a ramp of values 0 to 127 on CC 0, taking (10*128)
ms (~1.3 seconds) to complete the ramp, then it will do the same for CCs 1,2,3, and 4. You can use
the remap feature to set the CC numbers to a succession of your choice, rather than the linear range
using min and max.
Output from Tools
Displays the messages sent to the TWEAKER from the various functions in the Tools window.