Adjustments, Lubricating – Dake Model 14-10 User Manual
Page 4
7/22/03
Model 14-10
4
Adjustments
Blade Tension Handle (Item A) – Used to remove and install saw blade.
Also used to set the correct blade tension – Be sure blade is tight.
Upper Blade Wheel Cant Adjustment (Items B&C) – If your saw should
get out of adjustment and the blade runs off the wheel or runs back
against the lip, loosen the two bottom bolts on the wheel slide. Turn the
set screw in or out to make the blade run approximately 1/32” away from
the lip on the back of the wheel. Tighten the two wheel slide bolts.
IMPORTANT: If the blade is allowed to run against the lip on the wheel it
will wear the lip off.
Lubricating
Gear Box: Your 14-10 gearbox is filled at the factory. Check the fluid
level on arrival, and then check every six months thereafter. Use 90
weight gear lube to maintain fluid level at the fill / check pipe plug.
A
C
B