Trigger bus (trig [0 ]), Figure 2-2 – Agilent Technologies U2781A User Manual
Page 25
Features and Functions
2
U2781A User’s Guide
13
Trigger Bus (TRIG [0..7])
Trigger Bus (TRIG [0..7]) is an 8- bit digital bus connected
from slot 1 to slot 6 to synchronize different USB modules.
This trigger bus enables the USB modules of passing trigger
signals to one another.
To have one of the modules to control the operation of the
other modules, set the particular module as MASTER and
the rest as SLAVE (refer to
Simultaneous Synchronization (SSI)
for more details). The control signal is sent from the
MASTER module to the SLAVE modules through this trigger
bus. See following figure for the bus architecture.
Figure 2-2
Block diagram of Trigger Bus (TRIG [0..7]) and Trigger Out
In addition, the trigger bus can also be used to carry out the
pre- configuration of the chassis and modules before any
triggering activities. Refer to
for
more information.
TRIG [0..7]
U2781A UG.book Page 13 Friday, November 25, 2011 10:51 AM