OZ Lifting Products Beam Clamp OM - Manual (Page 4)

Important Information and Precautions
This manual contains general instructions dealing with the normal installation, operation and maintenance
of the products described herein.
This product should not be installed, operated, or maintained by any person who has not read all the
contents of these instructions. Failure to read and comply with these instructions, warnings, or limitations
noted might result in bodily injury, death, or property damage. Contact the distributor for further explanation
if information is not fully understood.
It is the responsibility of the owner/user to install, test, maintain, and operate these products in accordance
with OSHA regulations, other federal, state, and local regulations, and ANSI standards.
Only trained and qualified personnel shall operate and maintain this equipment.
Maintain Records
Schedule and maintain records of regular inspection and maintenance of the product in compliance with
ANSI standards.
Record your Beam Clamp’s Serial Number on the front cover of this manual to allow for easier referencing.
Precautions
Do not use OZ Lifting products in conjunction with other equipment unless the system designer,
manufacturer, installer, or user has put the necessary safety devices in place.
Modifications to upgrade or alter these products should only be authorized by the original manufacturer.
Beam Clamp should be used for holding loads only within their load ratings.
These Beam Clamp meet or exceed the following standards:
CE
AS4991
ANSI B30.10
(For use with manual or powered hoists)
pg.4