Getting started – Videoswitch VS-28 User Manual
Page 5
VS Series 2
User Manual
Page 3
Video Switch
VST605C.DOC
2. Getting
Started
1/
Connect the switcher up as shown:
This diagram show the VS-28A. For other switchers, fewer camera inputs and
monitor outputs are available.
2/
Identify the 8 switches on the switcher which are visible through the cut-out in
the base of the unit near the front edge. Set all switches OFF except for
sections 1,2 and 3 which should ON (assuming 8 cameras).
3/
Switch ON the mains power. The switcher powers up in AUTO mode. Press a
camera select key to cancel the auto mode and view a particular camera.