Videoswitch Vi100 - Manual (Page 8)

Digital Recorder
4
1.3 Recording
The Vi100 Digital Recorder should now be fully operational and recording images from all
cameras. The default image retention period is 7 days for the Vi100-G80-4 and 14 days for
the Vi100-G160-9.
1.4 Routine Checks
If the Vi100 is not recording, the message
STOP will be displayed on top right of the video
monitor. This should only happen if no hard drive is fitted or if it is faulty.
Although the system is intended for continuous un-attended operation, it is recommended
that the user regularly check that images from all cameras replay correctly. Any
potential problems with the cameras or recording system will then be detected as soon a
possible, rather than continuing un-noticed until a critical incident needs to be recalled from
the system.
Similarly, when a CD has been created you should check that it plays back correctly,
before the images on the hard drive in the Vi100 become over-written. The CD may be
checked by either by playing it on the Vi100 or on a PC.
1.5 Care of the Hard Drive
The hard drive is a delicate mechanical item that should be handled with care. Before
moving a Vi100 that has been powered up, remove power and wait for 30 seconds for the
drive to stop spinning. This is a precaution to avoid possible damage to the hard drive.