Videoswitch Vi-series - Manual (Page 2)

Connecting a Vi-K1 Remote Keyboard
to a DVR
To control the main monitor
Using a CAT5 cable, connect the socket marked “OUT” on the Vi-K1 to the keyboard input on the
DVR marked “MAIN”.
To control a spot monitor
Using a CAT5 cable, connect the socket marked “OUT” on the Vi-K1 to the keyboard input on the
DVR marked “SPOT1”, “SPOT2” or “SPOT3”.
To address multiple DVRs
Refer to application note Vsd605a.pdf which is available on the Videoswitch web site.
Notes:
1. Use the CAT5 cable provided or any standard (i.e. non cross-over) CAT5 cable.
2. Make sure you use the “OUT” connector on the Vi-K1 to connect to the DVR.
3. The “IN” connectoron the Vi-K1 may be uconnected to the “OUT” connector of a second
Vi-K1 if multiple control points are required.