AT&T E5827 - Manual (Page 12)

9
Getting started
Belt clip & optional headset t
Install belt clip as shown below (if desired).
Plug 2.5mm head-
set into jack on side
of handset (beneath
small rubber flap).
NOTE: If the sound quality of the
headset is unsatisfactory, try unplugging
it, and firmly plugging it in again.
Snap belt clip
into notches
on both sides
of handset.
To release belt clip from
handset, lift one side of
the belt clip out of the
notch.
For hands-free telephone conversations, use any industry standard 2.5 mm headset
(purchased separately).
For best results, use an AT&T 2.5 mm head-
set. To order an AT&T 2.5 mm headset, visit our website at
www.telephones.att.com or call 1 (800) 222-3111. In Canada
dial 1 (866) 288-4268.