AEG LAVAMAT 88810 - Manual (Page 39)

39
Water inlet
Attention!
• An inlet hose is supplied and can been found inside the machine
drum.
• Do not use the hose from your previous machine to connect to
the water supply.
• This appliance must not be connected to the hot water system.
1. Open the porthole and extract the inlet hose.
2. Connect the hose with the angled
connection to the machine.
Important!
Do not place the inlet hose down-
wards. Angle the hose to the left
or right depending on the position
of your water tap.
3. Set the hose correctly by loosening
the ring nut. After positioning the
inlet hose, be sure to tighten the
ring nut again to prevent leaks.
4. Connect the hose to a tap with a
3/4” thread.
Always use the hose supplied with
the appliance.
Installation should comply with local
water authority and building regula-
tions’ requirements.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe op-
eration of the appliance.
If you cannot make the cold water
connection direct from the rising mains, you may be able to operate
the appliance from your cold water storage system.
There should be a minimum distance of 5.02m (16.5 ft) between the
appliance’s inlet and the bottom of the water storage tank.