AEG LAVAMAT 88810 - Manual (Page 19)

19
Starting a program
1. Check that the water tap is open.
2. Press the START/PAUSE key.
The program is started or it starts after the time delay set has elapsed.
3
If after pressing the START/PAUSE key the display shows “Door not
Closed”, the door has not been shut properly. Push the door firmly
closed and press the START/PAUSE key again.
Program progress
The display indicates the
stage of the program that is
currently being performed as
well as the time of the end
of the program.
3
During the washing cycle the
time of the end of the pro-
gram may change as the
program adjusts itself to different conditions (e. g., type and quantity
of laundry, out of balance spin detection, special rinses, etc.).
Interrupting a program/adding washing
Interrupting a program
• The wash program can be interrupted at any time by pressing
the START/PAUSE key. It is then re-started by pressing the key again.
• To stop the washing machine before the program has ended, turn the
program knob to OFF.
Important: Be careful if there is water in the appliance!
Adding washing
1. Press the START/PAUSE key.
• If “Door locked” and “Pause” are alternately shown in the display, it is
no longer possible to add washing, e. g. when the water level is too
high.
• If “Door openable” and “Pause” are alternately shown in the display, it
is still possible to add washing:
2. Open the door.
3. Add washing and close the door again.
4. Press the START/PAUSE key again. The program continues.
L I N E N / E A S Y C A R E
12.45
W a s h i n g
14.37
50C 800 aýýýýýaýaýaýaýaýaýaýaýa
TEMP. RPM OPTIONS OK TIME