VHT Special 6 Ultra Head - Manual (Page 4)

1 2 3 5 7 8 10
4 6
11 12 9
1. Power Switch: This switch turns the amplifier on or off.
2. High/Low Power and Standby switch: The Low-Power (triode mode) setting reduces the amplifier’s maximum output power to approximately
one-half of the Full Power (pentode mode) setting. Low-Power mode produces a richer and smoother tone, with earlier breakup than High-
Power mode. The middle position is Standby mode.
3. Watts Control: The Watts control adjusts the output tube’s operating voltage and maximum output power. Maximum Output power ranges
from ½ watt (fully counterclockwise) to 6 watts (fully clockwise).
4. Jewel Light: This light will be illuminated when the Power switch is in the On position; the jewel light will be off when the Power switch is in
the Off position.
CONTROL PANEL FEATURES VHT SPECIAL 6 ULTRA FEATURES
6 Watts Maximum Output Power
One 6V6 Output Tube
Two 12AX7 Preamp Tubes
Ultra (high gain) and Clean Inputs
Ultra (high gain) Control
Volume and Tone Controls
Footswitchable Boost Mode
Tube-Driven Effects Loop
Tube-Driven Preamp Line Out
11-Position Depth Control
3-Position Texture Switch
High/Low Power Switch
Watts Control
12” VHT ChromeBack Speaker, 60-watt, 16 ohm (Combo Only)
Switchable 4, 8, or 16 Ohm Speaker Output
Mod-friendly Eyelet-Type Board
Hand-Wired in China
3
4