Haws 8100 User Manual

Page 3

12/09

Model 8100

Page 3 of 5

TROUBLESHOOTING

PROBLEM

REPAIR CHECKLIST

1. No flow.

Check the main shut-off valve.

2. Water leak between joints or

fittings.

Tighten loose connections. If leak
persists, the application of hot water
will sometimes reseat improperly
applied joint compound. After 30
minutes wait and retest, a persistent
leak will necessitate reassembly and
additional sealant.

3. Insufficient water flow at shower.

3. a. Verify minimum 30 psi (2 ATM)

flowing supply line pressure.

b. Probable clogging of flow control

inside shower head. Unscrew
shower head off of elbow and clean
rubber flow control.

4. Water does not drain properly.

Check your drain system for debris.
Check the main waste line of your
building to see if it does handle the
capacity required for the entire
drainage system.

For more information about Haws products, see our website:

www.hawsco.com