Pure Highway 300Di - Installation Guide - Manual (Page 6)

4
Installation checklist
Before installation
Review car and existing audio installation and discuss options with customer:
Decide on where to mount the main unit and controller:
• Check where the existing tuner is fitted (on some cars this may be in the
boot) and consider where the Highway main unit might be installed.
• Check and agree suitable locations for the USB extension cable
(recommended for all installs as used for iPod/MP3 player connection
and software updates) and optional auxiliary input (3.5 mm) cable.
• Check for auxiliary inputs on the existing audio system which might be
used by Highway
• Discuss controller placement with the customer - consider cable length to
attach to controller box and accessibility and visibility from the drivers seat.
Decide on which antenna type with the customer:
• Best – external digital antenna with grounding to vehicle bodywork (e.g.
Pure Active Through Glass Antenna).
• Good – internal digital antenna with grounding to vehicle bodywork (e.g.
Pure Active Film Antenna).
• Alternative – other antenna – magnetic roof mounted mast or factory
fitted digital antenna.
• Check that the supplied antenna cable will reach or use a suitable
antenna extension (2.5m cable available from Pure).
• Discuss controller placement with the customer - consider cable length
to attach to controller box and accessibility and visibility from the drivers
seat.
During installation
Make sure the USB extension is installed in a convenient location.
Make sure the 3.5mm auxiliary input cable is installed in a convenient location.
Adjust the FM transmit frequency if required (In Australia this should be set
to 88.6 MHz) see page 16 of the Owner’s manual.