Pure Highway 300Di - Installation Guide - Manual (Page 10)

8
Spare parts
Spares and accessories are available for Highway 300Di. To order a spare part or accessory from the UK, please e-mail: [email protected].
To order a spare part or accessory from Australia, please e-mail: [email protected].
Installer settings
Installer settings are provided to enable the initial setup, to prevent unintentional
changing, these appear in a hidden menu. To access the installer settings:
1. Press , , , , in quick succession.
2. Turn the Select knob to browse through the following options and
press the Select knob to choose one.
Antenna input source
Choose the required source depending on the type of antenna you are using:
Connector 8 (powered) Choose this if using the external active
antenna or the internal film antenna .
Connector 8 (unpowered) Choose this if using the mag-mount antenna.
Connector 7
Choose this if using an existing car antenna.
Note: Unless the existing car antenna is specifically designed for digital radio
reception, performance is likely to be very poor to unusable.
Autotune
Performs a scan for digital stations as per initial start-up.
FM pass-through
Choose from two FM pass-through connection options:
Disabled Highway 300Di output effectively replaces all FM
stations when Highway is switched on (Default).
Enabled Highway 300Di output is blended in to the FM
waveband, alongside normal broadcast FM stations.
Software upgrade
Use this option to update Highway 300Di’s software if you have an update
available and loaded on a USB stick. See the Owner’s manual for more details.
Factory reset
Use this option to reset all settings including the installed settings above to
defaults.