Pure Evoke-1S - Manual (Page 12)

10
45 minutes
Sleep off
08:30
45
Timers cleared
To stop and reset the kitchen timer
To stop and reset the countdown timer to zero before
it sounds a beeping tone, press and hold down the
Timer
button for three seconds until you see the
message ‘Timers cleared’.
Setting the sleep timer
Evoke 1S has a sleep timer that switches your radio into
standby (or off if powered by a ChargePAK) after a set
time period.
To set the sleep timer
1. Press the Timer button, turn the Tune dial and
push to select ‘Sleep timer’
2. Turn the Tune dial to increase the duration of the
sleep timer from 15 to 90 minutes in fifteen minute
intervals. Press the Tune dial to start the sleep
timer.
The time remaining until shut-down is displayed on
the right of the full-screen time view.
To cancel the sleep timer
Press and hold the Timer button until you see the
message ‘Timers cleared’.
Timers cleared
Intellitext
To view Intellitext messages
1. Press Menu, then use the Tune dial to select ‘Intellitext’ and enter the Intellitext
menu. Push the Tune dial to select ‘View’ and access a list of stations for which
you have Intellitext information (if you see ‘No data’ you need to tune to a station
broadcasting Intellitext for a few minutes before information is received).
2. Push the Tune dial to select a station then turn and push the Tune dial to browse
Intellitext categories for that station.
To change Intellitext options
Press Menu, then use the Tune dial to select ‘Intellitext’ and enter the Intellitext
menu. Push the Tune dial to select ‘ Clear all’ to delete all stored Intellitext messages
immediately or select ‘Set timeout’ to delete old Intellitext messages after 1 week
(default) or 1 day.
EVOKE_1S_manual-UK-Aus.indb 10 6/25/2012 1:25:18 PM