Pure Evoke-2S - Manual (Page 15)

13
Setup options
Press the Menu button to access the options menu, turn the Tune dial to scroll
through the options and push the Tune dial to select.
Options available in digital radio
DRC
The DRC (Dynamic Range Control) value makes the quiter sounds in a digital radio
broadcast easier to hear at low volume or or in a noisy environment. Check with the
broadcasters to find out if they use DRC.
DRC full
Applies the DRC level as sent with the broadcast.
DRC half DRC level is set to half that sent with the broadcast.
DRC off Any DRC level broadcast will be ignored.
Autotune
Scans all digital radio frequencies for stations and automatically adds any new
stations found to the station list. This may take a few minutes. To stop an Autotune
press
Menu.
Station order
Change the order that digital radio stations appear in the list.
Alphanumeric
Lists all stations in alphanumeric order.
Active station Lists active stations first on the station list.
Multiplex Lists stations in groups according to their multiplex - a group of
stations broadcast by the same operator.
Trim stn. list
Removes inactive stations from the station list.
Options available in FM radio
FM tuning mode
Seek
When you turn the Tune dial, the radio tunes to the next station with a good signal.
Manual
When you turn the Tune dial, the radio tunes up or down the FM radio frequency range
by 0.05 MHz.
FM stereo mode
Choose from Stereo (default) or Mono. Mono may improve audio clarity where stereo
signals are weak.
EVOKE_2S_manual_UK-Aus.indb 13 7/13/2012 4:29:38 PM