Outback Power Systems FLEXware Mounting Plate Users Guide - Manual (Page 3)

Requirements and Warnings
The OutBack FLEXware Mounting Plate is listed by ETL to UL standard UL 508A Industrial
Control Panels.
Grounding Instructions – Any enclosures attached to the FLEXware Mounting Plate should be con-
nected to a grounded, permanent wiring system. For most installations, the negative battery con-
ductor should be bonded to the grounding system at one (and only one) point in the DC system.
All installations should comply with all national and local codes and ordinances. System grounding
as required by the National Electric Code, ANSI /NFPA 70-1996, is the responsibility of the system
installer.
The FLEXware Mounting Plate is designed for indoor mounting only with appropriate fasteners and
a secure mounting surface that can handle the full weight of an assembled system.
2