Night Owl X100-DVR4-5GB user manual - Manual (Page 78)

78
Chapter 21: Remote Access
21.2 Windows
®
– based Network Configuration
In this section you will determine basic information about your network
Make sure that the DVR is properly connected to the router/modem and
that you have a computer works with Windows
®
operating systems
connected to the same router.
Follow these steps to determine the basic information about your network:
1. Press the “Windows” key and the “R” key at the same time on
your computer’s keyboard. Type “cmd” and press the Enter key.
2. In the command prompt window, type ipconfig and press Enter.
Find the section called “Ethernet adapter Local Area Connection” or
“Wireless LAN Adapter Wireless Network Connection.”
3. Find the IPv4 Address (it may be named “IP Address” in some
versions of Windows). Write down this number.