Ultra Start 430 Series - Manual (Page 7)

Entering program mode is done by the following steps:
1) Make sure ignition is in the off position.
2) Turn the ignition key ON - OFF, leaving key in the OFF position.
3) Press and release the Valet button two times.
4) The siren will chirp one time to confirm entering program mode.
( If this does not happen, turn ignition off, wait five seconds and repeat steps 1-4).
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#1 - #2 then #3
3 - The siren will respond with the following:
1 Chirp Active Arming
2 Chirps Passive Arming
Repeat sequence to change selection
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#1 - #3 then #2.
3 - The siren will respond with the following:
1 Chirp Auto Lock Disabled
2 Chirps Auto Lock Enabled
Repeat sequence to change selection
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#3 - #3 then #2
3 - The siren will respond with the following:
1 Chirp Active Locks
2 Chirps Passive Locks
Repeat sequence to change selection
To change settings:
1 - Enter Program Mode - (Ignition ON-OFF, followed by Valet 2 times)
2 - Press & release transmitter buttons in the following sequence
#1 - #3 then #1
3 - The siren will respond with the following:
1 Chirp 3 Second Door Locks
2 Chirps 0.75sec Pulses
Repeat sequence to change selection
Passive / Active Arming
Enter Program Mode
Passive / Active Arming
Door Lock Timing
Ignition Auto Locks