Monoprice 4116 Wall Mount Bracket - Manual (Page 2)

(10) Lag Bolt Washer – d (6)
3
/
8
”x3.5” Lag Bolt – e (6) Concrete Anchor - f
(4) M4x30mm Machine Screw – i (12) M4/M5 Washer – k (4) ½” Plastic Spacer – l (4) ¾” Plastic Spacer - j
(4) M8x25mm Screw–m (4) M8x40mm Screw–n (4) M5x30mm Screw–o (4) M6x30mm Screw-p
Step 1 Mounting the Wall Plate to the Wall
Brick, Solid Concrete and Concrete Block Mounting:
Use the Wall Plate (part a) as a template to mark 6 hole locations on the wall. Three in the top row of slots and three more in the
bottom row. Make sure these holes are level and there is at least 8” distance between any two holes. Pre-Drill these holes with a
10mm masonry bit to at least 90mm in depth. Insert a Concrete Anchor (part f) into each of these holes. Make sure the anchor is
seated completely flush with the concrete surface even if there is a layer of drywall or the other material in front. Attach the Wall Plate
to the wall using 6 Lag Bolts (part e) and 6 Lag Bolt Washers (part d), as shown in Diagram 1-B.
Wood Stud mounting:
The Wall Plate (part a) MUST be mounted to two wood studs. Use a stud finder to locate two adjacent studs. It is a good idea to verify
where the studs are located with an awl or thin nail as shown in Diagram 1-A. Pre-drill a 80mm deep hole at the desired height in each
stud using a 6mm drill bit. Make sure these holes are in the center of the studs and level with each other. Use the Wall Plate as a
template to mark the location of the second hole in each stud. Drill pilot holes at each of the marked locations. Attach the Wall Plate to
the wall using the 4 Lag Bolts (part e) and 4 Lag Bolt Washers (part d).