Monoprice 3323 Wall Mount Bracket - Manual (Page 3)

Step Two:
Assemble the display mounting plate assembly. Connect the display plate
(part K) to the “C” bracket (part I) and insert the small retaining bolt (part D)
through the front of the mounting plate, into the hole in the “C” bracket and
secure it with the retaining knob (part F).
Figure 2
Step Three:
After having prepped your flat panel display by removing any table top
stands as instructed in the manual for your display, attach the display
mounting plate assembly from step 2 to the back of your display.
Make sure it is in the correct orientation. The square shaped hole on
the “C” bracket should be on the top. Use four of the machine screws
included with the mount (Part G or H) or included with your display to
attach the plate to the back of the display. If none of the included
screws fit, contact the manufacturer of your display to find out the
appropriate size needed and purchase them at a local hardware store.
Figure 3
Step Four:
Figure 4
Have some one assist you by lifting the display with the attached
display plate assembly up to the extension arm on the wall plate
assembly from step one. Attach the “C” bracket to the end of the
arm and fasten it with the large retention bold (part C). Lock the
bolt in place with the nut (part E). When fastening the nut, so not
apply more than 17.6 lbs of tork.
Step Five:
Snap the outer plastic shells onto the wall plate and arm frame and you’re done (parts L, M & N).
Figure 5
Congratulations! You’re Done.