beautypg.com

Installation – Monoprice 10222 Amplified Digital Keypad Wall Plate with Bluetooth and Analog Audio Inputs User Manual

Page 5

background image

Monoprice Self Amplified Digital Keypad with Bluetooth and Analog Inputs

5

INSTALLATION

1. Connect a pair of speaker wires from the installed speakers to the OUTPUT terminal

block on the device. Pay close attention to left/right orientation and ensure that the
+/- polarity is properly maintained.


2. Obtain a 24 VDC power source (not included). Connect the positive output of the

power source to the V+ terminal and the negative output to the G terminal. Once
power is applied the unit will be in standby.


3. (Optional) If you intend to use the IR repeater functionality, connect the positive wire

from an IR Transmitter/Emitter to the IR OUT + terminal and the negative wire to the
IR OUT - terminal. Position the IR bulb so that it can "see" the IR receiver on your
source device(s).













4. (Optional) If you want to make a hardwired internal connection, connect the audio

source right channel positive to the R+ terminal. Connect the audio source left
channel positive to the L+ terminal. Finally, connect the audio source negative wires
to the G terminal between the L+ and R+ terminals.


5. Test the unit to ensure that all inputs and outputs are operating properly. Check the

balance of the speaker volume. If it is not in proper balance, you can adjust the
balance using the Balance Trim Pots on the back of the amplifier.


6. Mount the plate as desired. After it is secured in place, install the front cover to hide

the installation screws.

DVD

IR EMITTER

Hi

Lo

INPUT

LEVEL

AUDIO IN

L

R