Monoprice 6029 Speaker Volume Control - Manual

Model：SVC-RT-100W
INSTRUCTION
1. Remove about 1/4” of insulation from the ends
of all wires to be connected to the volume
control and twist the exposed strands.
2. The removable connectors accept up to 14 gauge
wire.
3. Loose the set screws on the Volume Control.
4. Connect the leads from AMPLIFIER to the set
screws on the volume control labeled INPUT, with
the LEFT L(+) and L(-) and RIGHT R(+) and R (-)
wires. Inserted in the appropriately marked
opening.Tighten the screws firmly.
5. Connect SPEAKER wires to the set screws on the
volume control labeled OUTPUT, observing +
(positive) and - (negative)polarity of left and right
speaker.
6. Install the completed assembly in the junction
box. Insert carefully to avoid excessive strain on
the set screws. If necessary, pre-dress the wires
for easiest mounting.
Be careful not to allow speaker wire strands
to short out against case or other speaker
wire.
O U
P U
T
I N
P U
T
OUT I N
Mounting depth:2.95”(75mm) from finished wall.
X4
X2
X8
X1