Audiovox Rampage ACD95 - Manual (Page 14)

128-6566
14 of 20
14 14 14 14 14
CD CHCD CHCD CHCD CHCD CH
AAAAA
NGER CONTRNGER CONTRNGER CONTRNGER CONTRNGER CONTR
OLOLOLOLOL
SSSSS
NO NO NO NO NO
TES ON FRTES ON FRTES ON FRTES ON FRTES ON FR
ONT PONT PONT PONT PONT P
AAAAA
NEL / SETNEL / SETNEL / SETNEL / SETNEL / SET
TTTTT
ING THE CLOCKING THE CLOCKING THE CLOCKING THE CLOCKING THE CLOCK
MANUAL SEEK TUNING – See Main
Unit
bm
,except press and hold to
Seekupward, press and hold to
Seek downward.
CD TRACK SELECT – See Main
Unit
cr
, except press to select
a higher track number, press to
select a lower track number.
CD CUE/REVIEW – See Main Unit
cs
, except press and hold for
Cue Function, and press and hold
for Review function.
7 7 7 7 7
AUDIO MUTE (MUTE) - See Main Unit
bs
.
8 8 8 8 8
EQUALIZER (EQ) - See Main Unit
9
.
1 1 1 1 1
POWER ON/OFF - See Main Unit
1
.
2 2 2 2 2
MODE SELECTOR (MODE) - See Main Unit
bn
.
3 3 3 3 3
INFRARED SENDER - Emits infrared sig-
nal to radio which is detected by the sen-
sor.
4 4 4 4 4
VOLUME (VOL) CONTROL- See Main Unit
2
.
5 5 5 5 5
SELECT BUTTON (SEL) - See Main Unit
3
,
4
,
5
,
6
, and
7
.
6 6 6 6 6
TUNE/SEEK CONTROL – See Main Unit
bm
, except press to increase
frequency, and press to decrease
frequency.
If a problem should develop while operating the CD changer, the following error codes
may appear on the display panel.
ER-1: Indicates that there is no magazine loaded in the CD changer.
ER-2: Indicates a problem with the magazine eject function.
ER-3: Indicates an error in the disc loading function.
ER-4: Indicates an error in the disc un-loading function.
ER-5: Indicates an error in the magazine position.
ER-6: Indicates an error in the laser pick-up position.
ER-7: Indicates an error in the laser focus on the disc.
In any of the above situations, try ejecting the CD magazine from the changer and make
sure the discs are clean, undamaged, and loaded correctly (refer to the Owner’s Manual
of the CD changer). Re-load the magazine and check for proper operation. You may also
try activating the RESET button
dp
on the unit, but this will also erase the time and pre-
set memories.
If the suggested measures do not solve the problem, contact an approved warranty station
near you for further assistance.
CD CH CD CH CD CH CD CH CD CHA A A A ANGER ERR NGER ERR NGER ERR NGER ERR NGER ERROR CODES OR CODES OR CODES OR CODES OR CODES
CD CHCD CHCD CHCD CHCD CH
AAAAA
NGER ERRNGER ERRNGER ERRNGER ERRNGER ERR
OR CODES / WIRELESS REMOOR CODES / WIRELESS REMOOR CODES / WIRELESS REMOOR CODES / WIRELESS REMOOR CODES / WIRELESS REMO
TE CONTRTE CONTRTE CONTRTE CONTRTE CONTR
OLOLOLOLOL
WIRELESS REMOTE CONTROL OPERATION