Yetter 2967-064 Residue Manager - Manual (Page 9)

9
OPERATION PRECAUTIONS
STOP
Read this before using the Yetter product.
- MACHINE OPERATION
IMPORTANT: failure to properly set the planter frame height and levelness
can result in less than successful operation of the planter and the Yetter
product and may result in damaged equipment. All operators should read
and thoroughly understand the instructions given prior to using the Yetter
product.
NOTE: DO NOT use this product if the planter is not adjusted properly!
Leveling the planter:
With the planter lowered to proper operating height (Usually 20”-22”). Read the
planter operator’s manual for recommended setting. Check to be sure the
toolbar and row unit parallel arms are level fore and aft. Re-check when the
planter is in the field and has been fully loaded with seed, fertilizer, granular
chemicals, etc. Also, a field check with a bubble level on the frame should be
made of the hitch height to ensure level operation front to back.
It is important for the planter to operate level laterally. Tire pressure must be
maintained at pressures specified by the manufacturer.
Field and actual planting conditions change and will dictate planter frame heights.
You must ensure that the row unit parallel arms are approximately parallel with
the ground.
IMPORTANT: For proper operation of the planter attachments and row
units, it is imperative that the planter toolbars and row unit parallel arms be
level side-to-side and front-to-rear. The toolbar frame should operate at a
20”-22” height from the planting surface. Check the manufacturer’s
operator’s manual for instructions on how to adjust the frame height and
levelness.