Assembly instructions – Yetter 2961-010-015 Cut and Move Coulter/Residue Manager Opener User Manual

Page 7

Text mode
Original mode

ASSEMBLY INSTRUCTIONS

2961 – CUT AND MOVE

STEP 6.

NOTE: When assembling the residue manager wheel, hub cap and bearing hub; make right

hand and left hand assemblies. Also, be sure the slot in the R.M. wheel is in alignment with small hole in
bearing and the groove on inside of hub cap. Assemble the 5/8” x 4” d-bolt and 3/16 thick flat washer onto
the bearing hub. Now attach the residue manager wheel and hub cap to the bearing hub using 4) 5/16” x 1-
1/2” carriage bolts and lock nuts.

STEP 7.

Onto the residue manager wheel assembly, install the 2967-302 – ¾” spacer, 2967-336 –

shield, ¼” flat washer and attach to the 2967-247 – stem using lock washer and installed in the rear hole of
the 2967-247 stem. Torque 150 ft.lbs.