Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit - Manual (Page 5)

7.Working on the driver side, remove the bolt that connects
the brake line bracket to the frame rail. Save hardware and
repeat on passenger side.
8. Working on the driver side, un-bolt the ABS sensor from
the steering knuckle and move ABS wire harness aside and
out of the way. Repeat on passenger side. Special note: Be
careful not to put ABS sensor and wire harness any-
where that it can be damaged during install.
9. Working on the driver side, un-bolt the brake caliper from
the steering knuckle, save the stock bolts for re-install. Now
remove brake caliper and carefully tie it up out of the way
during install. Repeat on passenger side. Special note:
when removing brake caliper, take special care not to
bend or kink the hard brake line.
10. Working on the driver side, remove the brake rotor from
the hub and set aside for later re-install. Repeat on passen-
ger side.
11. Working on the driver side, remove the cap in the center
of the hub assembly, then remove cotter pin and retaining
nut, now remove the large axle nut and save all stock hard-
ware for later re-install. Repeat on passenger side.
12. Using a rubber mallet or anything similar, tap the CV axle
loose from the knuckle in the hub assembly. Special note:
take special care not to damage the threads on the end
of the axle shaft.
13. Working on the driver side, remove the cotter pin from
the upper ball joint nut, then loosen but don’t remove the nut
completely. Repeat on passenger side.