Tuff Country 56900 - Toyota Tacoma 05-14 6 lift kit - Manual (Page 18)

70. Working on the driver side, using the stock bolt, install
the stock ABS wire bracket to the lower mounting position on
the new steering knuckle. Repeat on passenger side.
71. Working on the driver side, using the stock bolt, install
the ABS sensor into the new steering knuckle. Repeat on
passenger side.
72. Working on the driver side, remove the stock outer tie rod
from the inner tie rod. Carefully cut 5/16” off the end of the
stock outer tie rod. Install the modified outer tie rod to the
stock inner tie rod. Repeat procedure on the passenger side.
73. Working on the driver side, install the tie rod end into the
new steering knuckle and secure using the stock nut and
cotter pin. Torque to 48 ft lbs. Special note: If you are not
able to install the stock cotter pin because the hole in
the tie rod does not line up with the castle nut, DO NOT
loosen, tighten the castle nut until the stock cotter pin
can be installed. Repeat on passenger side.
74. Locate (1) S10105 from hardware bag 56900NB1.
Locate (1) 10 mm x 50 mm hex screw, (1) 10 mm flat wash-
er and (1) 10 mm lock washer from hardware bag 56900NB
bag # 1. Working on the passenger side of the front differen-
tial, use the new spacer sleeve and hardware to space the
wire harness bracket upwards. Make sure to use thread
locker or loctite and torque to 8 ft lbs.