Tuff Country 53905 - Toyota Tacoma 05-14 3 uni-ball lift kit User Manual
Page 3
Hardware bag 50930PL includes:
Description
Quantity
PB69137 Poly upper control arm bushings 8
S10248 .750”x.555”x2.280 crush sleeve
4
SERT05 Grease Fitting
4
Hardware bag 52907NB includes:
Description
Quantity
14WA 1/4” USS flat washer
2
M840B 8mm x 40mm bolt
2
126B 1/2” x 6” bolt
2
12UN 1/2” unitorque nut
2
M850HEX 8mm x 50mm hex head bolt
1
916HN 9/16” ubolt high nut
8
Sleeve bag 52907SL includes:
Descripton
Quantity
S10025 1.250” X .563” X 1.000” Sleeve
2
S10051 1.750” X .510” X .950” Sleeve
2
S10105 1.000” X .325” X 1.300” Sleeve
1
Hardware bag 50930NB includes:
Description
Quantity
S10246 Uniball alignment sleeve
2
S10245 Uniball alignment sleeve (tapered) 2
S10140 9/16” x 2” fender washer
4
9165B (9/16” x 5” bolt)
2
12WA 1/2” USS flat washer
4
916UN 9/16” unitorque nut
2
14UN 1/4” unitorque nut
2
14WA 1/4” USS flat washer
2
Recommended tools selection:
Wall mounted strut compressor
Torque wrench
Standard socket set
Standard wrench set
Metric socket set
Metric wrench set
Tape measure
Hydraulic floor jacks
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_______________________________
Passenger side front:___________________________
Driver side rear:________________________________
Passenger side rear:____________________________
At the end of the installation take the same measure-
ments and compare to the pre-installation measure-
ments.
Post installation measurements:
Driver side front:______________________________
Passenger side front:__________________________
Driver side rear:_______________________________
Passenger side rear:___________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely
lift the front of the vehicle and support the frame with a pair
of jack stands. Place a jack stand on both the driver and
passenger side. Next, remove the wheels and tires from
both sides.
2. Remove the front skid plate and save the skid plate and
hardware for later re-installation.
3. Working on the driver side, remove the sway bar end link
from the knuckle. Save the hardware for later re-installa-
tion. Repeat procedure on the passenger side.
4. Working on the driver side, remove the cotter pin that
connects the knuckle to the upper control arm. Save the
cotter pin for later re-installation. Loosen but do not remove
the castle nut that secures the knuckle to the upper control
arm. Carefully break the stock taper in the upper control
arm and the knuckle. Once the taper has been broke,
remove the castle nut and set aside for later re-installation.
Repeat procedure on the passenger side.