Tuff Country 52000 - Toyota FJ Cruiser 07-13 3 lift kit - Manual

Part #: 52000
2007 Toyota FJ
3” front / 2” rear suspension system
Parts list:
Part # Description Qty.
52907-01 Pre load spacer 2
52907-02 Strut spacer 2
MO3531BK-01 Rear coil spring spacers 2
52000NB Hardware bag 1
52000INST Instruction sheet 1
MIRRORHANGER
Rear view mirror hanger 1
WARNINGDECAL
Warning decal 1
Special Note: A strut compressor is going to be
needed to perform this installation. If you do not have
a strut compressor you may rent one from your local
Auto Parts store.
Congratulations on your selection to purchase a Tuff
Country EZ-Ride Suspension System. We at Tuff
Country EZ-Ride Suspension are proud to offer a high
quality product at the industries most competitive
pricing. Thank you for your confidence in us and our
product.
For a list of all parts, please refer to the Parts
Description Page, at the end of the Installation Manual.
Make sure to use thread locker or locktite on all new
and stock hardware associated with the installation of
this suspension system.
The Tuff Country EZ-Ride Suspension product safety
label that is included in your kit box must be installed
inside the cab in plain view of all occupants.
After the original installation, Tuff Country EZ-Ride
Suspension also recommends having the alignment
checked every 6 months to ensure proper tracking,
proper wear on tires and front end components. Tuff
Country EZ-Ride Suspension takes no responsibility
for abuse, improper installation or improper
suspension maintenance.
Installation manual
3” front / 2” rear
suspension system
2007 Toyota FJ
Part # 52000
sj110607rev.03
Important customer information
Tuff Country EZ-Ride Suspension highly recommends
that a qualified or a certified mechanic performs this
installation.
If you desire to return your vehicle to stock, it is the
customers responsibility to save all stock hardware.
It is the responsibility of the customer or the
mechanic to wear safety glasses at all times when
performing this installation.
It is the customers/installers responsibility to read
and understand all steps before installation begins.
OEM manual should be used as a reference guide.
This vehicles reaction and handling characteristics
may differ from standard cars and/or trucks.
Modifications to improve and/or enhance off road
performance may raise the intended center of gravity.
Extreme caution must be utilized when encountering
driving conditions which may cause vehicle imbalance
or loss of control. DRIVE SAFELY! Avoid abrupt
maneuvers: such as sudden sharp turns which could
cause a roll over, resulting in serious injury or death.
It is the customers responsibility to make sure that a
re-torque is performed on all hardware associated with
this suspension system after the first 100 miles of
installation. It is also the customers responsibility to
do a complete re-torque after every 3000 miles or after
every off road use.
Torque settings:
5/16” 15—18 ft lbs.
3/8” 28—32 ft lbs.
7/16” 30—35 ft lbs.
1/2” 65—85 ft lbs.
9/16” 85—120 ft lbs.
5/8” 95—130 ft lbs.
3/4” 100—140 ft lbs.