Tivax LSS-602 - Manual (Page 9)

Presser Foot Lifter
Presser foot lifter
The presser foot lifter raises and lowers the
presser foot.
Thread Cutter
Thread cutter
You do not need a pair of scissors to cut the
thread after sewing. Simply use the built-in
thread cutter.
Extension Table
Detaching the table
Pull the table away from the machine for
“free-arm” sewing of cuffs and sleeves.
Attaching the table
Push the extension table until it snaps into
the machine.
Pin
Holes
Tab
Free-arm
Accessory box
Open the cover of the accessory box toward
you. The sewing accessories are conveniently located in the box.
•
•
•
SECTION . GETTING READY TO SEW
4
Stitch
Straight stitch: 1
Zigzag stitch: 2 to 12
Starting to sew
Raise the presser foot and position the fabric on the needle plate. Turn the handwheel
and lower the needle to the point where you want to start. Lower the presser foot and
pull the threads toward the back. Depress the foot control. Gently guide the fabric
along a seam guide line letting the fabric feed naturally.
CAUTION: Do not place fingers near the presser foot when guiding fabric, or the
needle clamp screw may strike and injure your fingers.
Finishing sewing
To fasten the ends of a seam, press the reverse stitch control and sew several reverse
stitches. Raise the presser foot. Remove the fabric, draw the threads to the back and
cut them with the thread cutter. The threads are now the proper length to begin
sewing the next seam.
•
•
SECTION . SEWING
15