Spyder Auto CCFL and LED - Manual (Page 2)

Connect the CCFL Inverter to the CCFL wires on
the headlight. The inverter is a Snap-on plug.
The CCFL wires comes with a heat shrink wrap, use
a heat gun or a lighter to shrink the plugs together.
When using a lighter, make sure to heat on the wrap
and not on the wires itself.
Connect the CCFL Inverter with the L.E.D. wires
Using the quick connect, connect the CCFL inverter
Positive(white). Same goes with Negative wires
Use the Crimper to close the quick connects to-
gether. Check the wiring after connecting, make
sure it is connected properly.
Check all connections before installing the
headlights onto the vehicle. Connect the Posi-
tive and Negative wires to the battery terminal
to see if all CCFL and L.E.D.’s are lid up.
STEP:2 PRE-WIRING