Spyder Auto HALO and LED - Manual (Page 3)

Most users connect the HALO/L.E.D.’s on the parking/
running lights. This instruction, we’re gonna connect to the
Parking/Running lights.
First, locate the parking lights on your vehicle Head-
light housing. Some Parking lights come with
two (running lights, ground) or three (running lights,turn
signal,ground) wires.
To determine which wires are what on the Parking
lights, we use a volt meter.
The volt meter has a positive(red) and negative(black)
needles. First turn on the parking light and signal on.
Then Pinch the Negative needle to a ground or negative
wire(as shown). Then Pinch the Positive wire to one of
the color wires on the turn signal.
To understand how to read the volt meter in simple term;
When the needle stays constant on high voltage, the wire that
was pinch is a Running/Parking light. Meaning the parking
light on your vehicle stays on whenever the lights are turned
on.
If the needle bounces on the meter, the wire is a turn
signal. The voltage to the turn signal pull high and low
in order for the turn signal to blink.
We don’t recommend to
Once you locate the running wires, use the quick connects
and connect the HALO/L.E.D. Positive wires to the running
lights.
STEP: 3 Connecting to Parking/Running Lights