Spyder Auto Dodge Charger 06-09 Headlight with LED - Manual (Page 3)

The front bumper should come off easily from the frame.
Remove the headlight assembly from the vehicle.
There are three screws, two on the top, and one on the
bottom of the headlight.
Install the Mounting Bracket first onto the car, align
the screws where you mount the OEM Headlights. (as
shown)
After installing the mounting bracket for both side, put the
front bumper back on the car. Bolt all the screws back on the
bumper.
Install the Low Beam, High Beam, and turn signal onto
the new headlight. The L.E.D. wires are connected to
the Corner Bumper lights.
The new headlight should slide thru the bumper onto
the mounting bracket.
Once you align the screw to the mounting bracket, bolt the
screws back on using a 10mm socket. There are four mount-
ing point behind the headlight.
STEP 2: Removing Bumper/Install Bracket/Headlight