Sper Scientific 800007 Thermometer 2 Channel Type K/J - Manual (Page 6)

6
1 . The max value is updated only when
exceeded .
2 . With the meter on, press the MAX/MIN
button once . “MAX” and the maximum
(peak) temperature appear on the LCD .
3 . The min value is updated only when a
lower temperature is recorded .
4 . Press the MAX/MIN button again .
“MIN” and the minimum temperature
appear on the LCD .
5 . Press the MAX/MIN button again . “AVG” and
the average temperature appear on the LCD .
6 . The max/min/ave temperatures are held in
memory until the meter is turned off .
7 . To exit this mode, press and hold the
MAX/MIN button for at least 2 seconds .
The current temperature appears on the LCD .
Note…
The primary display shows current channel
readings of min/max/ave . The lower display
shows current channel readings of actual
temperature . For model 800007, to view
another channel reading of min/max/ave,
press and hold the T1-T2 button to switch
from T1 to T2 and vice versa .
MEASUREMENT PROCEDURES