Sper Scientific 810032 Stopclock - Manual (Page 2)

INSTRUCTIONS
1. Open the battery compartment and remove the
tab between the battery and the contact point.
2. Select lap or cumulative time by pressing the
MODE (blue) button. The upper display
flashes the mode.
3. Press the START/STOP (green) button
to start or stop the unit.
4. Press the SPLIT/LAP/RESET (red) button
to record the lap or split time.
5. To reset the display to zero, press the
STOP (green) button, then press the
RESET (red) button.
The stopclock has three 4 mm sockets for external
triggering. These should be connected as follows:
Red = Reset Blue = Neutral Green = Start/Stop
Precautions: Do not use in environments
which are very hot or humid. Do not clean with
abrasive or corrosive substances. Do not drop or
shake vigorously. Do not open the unit.