Speedtech Brake Line Kit - Manual (Page 11)

10. Once you have all the lines clamped and the mounting brackets
attached to the vehicle, tighten the bulkhead fitting mounting nuts and all
tube end nuts.
Keep in mind that the fittings are aluminum and damage easily. Do not
cross thread or over tighten. They only need to be tight enough so that
they don't leak. The tube nut and sleeve combined with the flared end will
provide an adequate seal when installed properly.
11. Install the flex lines onto ends of the hard lines. The flex lines provided
for both the front and rear caliper connection will need adapter fittings for
the caliper side. All flex lines have the same end fittings, -3 JIC. Because
of the many different caliper designs, you will have to purchase the correct
adapter fittings for your calipers from your performance parts retailer.
12. Be sure to properly bleed the entire brake system before driving the
vehicle.
Speedtech Performance USA LLC
3884 S. River Rd. Bldg A
St. George, UT 84790
(435)-628-4300
11 | P a g e