Speedtech B Body Rear Coilover - Manual (Page 5)

5 | P a g e
Measure and mark the rear side of the factory bracket 3” above the 1/2” bolt.
Using your mark, drill a 7/16” hole through both the factory and Speedtech
bracket. Install one 7/
16 x 1 1/4”, (2) 7/16” washers, and one 7/16” Nylock nut
through the hole and tighten.
Using the pre-
drilled hole in the Speedtech bracket as a guide, drill a 7/16” hole
in the side of the factory bracket. Use one 7/16 x 1 1/4” bolt, (2) 7/16” washers,
a
nd one 7/16” Nylock Nut and tighten down.