Speedtech A Body rear Trailing Arms - Manual (Page 5)

5 | P a g e
5. Remove the factory lower trailing arms. Adjust the Speedtech lowers as
needed in the same manner as the uppers. Install the trailing arms with the new
bolts. Raise the axle to ride height and recheck pinion angle. If the angle is off,
remove the rearward end of the lower trailing arms. Adjust the driver's side arm
and reinstall. Adjust passenger arm to match bolt hole alignment and reinstall.
Check pinion angle again. Repeat process until desired pinion angle is achieved.
6. Check to make sure the rear axle is laterally centered side to side in the car
and the wheels are centered front to back in the wheel opening. Adjust trailing
arms as needed. Always be sure pinion angle is rechecked as centering
adjustments are made.
7. Reinstall coil springs and shocks.