Speedtech 70-81 Camaro T56 Crossmember - Manual (Page 3)

3 | P a g e
Before you begin- These first set of instructions are for
‘70-74 Camaros.
There are additional instructions for
‘75 and up Camaros starting on page 5.
1. Assemble the Stainless adjusters to the frame plates. Use Antiseize on all
bolts.
2. With the old transmission crossmember removed and your T56 held in place
with a tranny jack, install the right and left side frame mount plates on top side
of the frame rail. These frame mounts go on specific sides and are marked
accordingly. If it is too tight to fit the brackets in place you may need new body
mounts. Only hand tighten them at this time.
3. With Antiseize on the bolts, install crossbar to the side plates and slide the bar
forward or back until it lines up with the transmission mount (Speedtech part #
220531 or Energy Suspension # 3-1108G).