Airlink101 ASOHORL - Manual (Page 8)

8
1. Insert the Boot ROM into the socket on the
Adapter.
2. Refer to the installation procedures provided
by the network operating system.
Troubleshooting
If you experience any problems with the Adapter,
first verify that the appropriate driver is loaded, that
the proper grade of cable is employed for the
network connection, and that the supporting hub is
functioning properly.
1. Verify that the Adapter is fully and firmly
seated in the slot connector.
2. Check the length and rating of the connecting
cables.
3. Verify that the Adapter's PCI slot is not
deactivated at the BIOS level. The CMOS
Setup utility of the computer ordinarily
provides the option to activate or deactivate
PCI slots.
4. Replace the Adapter in question with a verified
Adapter and run RSET8139.EXE diagnostic
tests from the \DIAG\ folder of the floppy disk.
5. Install the Adapter to another PCI computer
and run the tests again.
Remove all other PCI adapters from the computer
and run the tests again. If the verification/diagnostic