Schumacher 71486 5SEARS - Manual (Page 12)

• 9 •
tROUBLESHOOtInG 11.
PROBLEM POSSIBLE CAUSE REASOn/SOLUtIOn
The jump starter won’t jump
start my car.
Clips are not making a good
connection to the battery.
The jump starter battery is
not charged.
The vehicle’s battery is
defective.
Check for poor connection
to battery and frame. Make
sure connection points
are clean. Rock the clips
back and forth for a better
connection.
Check the battery charge
status by pressing the button
on the front of the jump
starter. See LEd Indicators
section of this manual.
Have the battery checked.
The jump starter won’t
power my 12v device.
The 12v device is not
turned on.
The jump starter battery is
not charged.
The 12v device draws more
than 15A or has a short
circuit
Turn on the 12v device.
Check the battery charge
status by pressing the button
on the front of the jump
starter. See LEd Indicators
section of this manual.
disconnect the 12v device.
The internal breaker will
automatically reset after a
minute or two. Try the 12v
device again. If it happens
again, replace the 12v
device.
The battery in the jump
starter won’t hold a charge.
The battery is bad (will not
accept a charge).
Have the battery checked.
The jump starter alarm is
on.
Connections are reversed. disconnect the jump starter
and reverse the clips.
SPECIFICAtIOnS 12.
Internal Battery Type dieHard Maintenance-free AgM Lead-acid
Nominal voltage 12v dC
Capacity 12 Ah
dC Power Outlet (Max. Continuous Load) 15A With Automatic Circuit Breaker Reset
Built-in Light Bulb (Replaceable) 5w/12v dC (Base type BA9S)
Jumper Cables 8-gauge AWg, 18 Inches
dimensions (H x W x d) 9.5 H x 10 x 8 Inches
Product Weight 12.2 Lbs.
REPLACEMEnt PARtS/ACCESSORIES 13.
Male-to-Male Accessory 12v Charging Connector ----------------------- 94500109